![]() Otherwise, seems well-built and durable and whatnot.other than the fact that you're sharpening with exactly the same spot on your stone over and over again.Snowboards need a little TLC to keep gliding smoothly on the slopes. It'll be much easier, and you'll get better results. If you want to use it as a guide because you don't trust yourself to free-hand sharpen with a diamond stone or such, then maybe, but I think you'd be better off with simply a blue diamond stone, and free-hand it carefully. In either case, you'll have much better, dedicated tools for this. I don't like this tool - what's the point? I don't think you should be re-setting the angle on your edges unless you're a shop, of you really know your stuff. This is not a problem if you are paying attention and clean the tool as needed. ![]() You do have to be somewhat carful when using the mill file as burrs tend to get caught along the sliding surface of the tool and can put minor scratches on the base of the skis. The tool is a little tough to handle on the front and back curves of the ski, though not a big deal. Easy to set the stone in different positions for more even wear. Setting the angle is easy, changing the stone from side edge to bottom edge is easy. Be careful to properly anchor your ski and clean the debris from the tool after every other pass. I live in South Carolina now and it does a good job.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |